Features#
BB-Config v1.x#
PRU Enable/Disable#
Enable/Disable PRU
![pru](../../_images/pru.png)
GPIO#
Turn On/Off gpio
GPIO Setting#
![gpio setting](../../_images/gpio2.png)
EMMC and MicroSD Stats#
Storage stats & grow partition
![emmc](../../_images/emmc1.png)
LEDs#
Config board build in LEDs
![leds](../../_images/leds1.png)
Password#
Change users password
![password](../../_images/password.png)
SSH#
Enable/Disable SSH
![ssh](../../_images/ssh.png)
WiFi#
Connect to Wi-Fi
![WiFi](../../_images/wifi.png)
Internet Sharing and Client Config#
![ics](../../_images/ics.png)
Note: You’ll have to configure your host Following is an example script:
echo 1 > /proc/sys/net/ipv4/ip_forward
iptables --table nat --append POSTROUTING --out-interface wlp4s0 -j MASQUERADE
iptables --append FORWARD --in-interface wlp4s0 -j ACCEPT
About#
![about](../../_images/about.png)
BB-Config v2.x#
ADC (Graph)#
Plot graph for Analogue pin
![adc page](../../_images/adc2.png)
![adc graph](../../_images/adc1.png)
DAC (PWM)#
Generate PWM waveform
![pwm](../../_images/pwm.png)
uEnv#
Enable/Disable boot configuration
![uEnv](../../_images/uEnv.png)
services#
Enable/Disable services startup at boot
![service](../../_images/service.png)
PINMUX#
Display PIN I/O detail
Config PINMUX
Hardware Display#
![pinmux hardware](../../_images/pinmux.png)
Pin Table References#
![pinmux table references](../../_images/pinmux2.png)
Pin Config#
![pinmux config](../../_images/pinmux3.png)
Overlay (dts)#
Enable/Disable Device Tree Overlay in Boot option
Select dtbo file and automate update in uEnv.txt
![overlay](../../_images/overlay.png)
WiFi (D-Bus)#
Connect to WiFi with wpa_supplicant
Support for Debian 11
![WiFi D-Bus](../../_images/wifi-dbus.png)